PRODUCTS

ISOWEIR ZEEPSON ZEMİN (SOLVENTSİZ)

ISOWEIR ZEEPSON FLOOR is a solvent-free epoxy resin based, two-component, water and solvent resistant, hygienic top coat coating material that can show superior resistance against physical and chemical factors.

AREAS OF USE

  • In food production facilities, hospitals, cold storages,
  • Swimming pools and other pools,
  • Petroleum, fuel oil, paraffin, oil, diesel oil, storage tanks containing various concentrations of acids and various solvents,
  • Parking garage floors,
  • Cargo warehouses, ballast tanks, water tanks and other tanks.

APPLICATION

Surface Preparation:

  • Metal surfaces should be sand blasted at SA 2,5 and the blasted surface should be cleaned with dry air.
  • If the concrete is new, the floor concrete should be cured (~ 21 days) and the moisture content of the concrete should not exceed 4%.
  • Concrete surfaces should be thoroughly cleaned, dust and loose particles should be removed with rotating steel or vacuum cleaner, cracks and eyelet holes should be filled.
  • After surface preparation, the concrete floor should be primed with suitable ISOWEIR ZEEPAS primer material and made ready for topcoat application.

Product Preparation and Application:

  • The mixing ratio should be 20 kg of Component A and 4 kg of Component B by weight.
  • Component A should be mixed with a low speed mixer until homogenized.
  • Then Component B should be added to component A and the mixture should be mixed at about 100 rpm for at least 2 minutes.
  • As the amount of contents you are mixing increases, you may need to increase your mixing time or mixing speed.
  • As soon as you start mixing, there will be a cloudy appearance in the system at first, and as the mixing continues, it will start to become transparent again.
  • Scrape the finished mixture into another clean container and mix again.
  • You can complete your process by pouring the mixture you mixed for the second time into the area where you will apply.
  • To minimize air entrainment (to avoid bubbles), mixing should not be done for too long and at high speed.
  • Spilled material should be spread on the surface with a steel trowel and any gas bubbles should be removed with a spiked roller.

Points to be Considered:

  • Eyes should be protected during the application.
  • It is recommended to wear gloves.

FEATURES, ADVANTAGES:

  • Being solvent-free, it can be safely used in closed areas, water tanks, food and hygiene areas where compliance with hygiene conditions is required.
  • It can be used as coating and insulation material in drinking water tanks.
  • It is an antitoxide.
  • When used in water tanks, there is no change in the taste and odor of water.