ISOWEIR İZOÇATI is a structurally flexible roof insulation plaster that does not contain bitumen, cement or mineral stones. İzoçatı is a high adhesion product that can be used as a topcoat in the roof system and can provide 100% waterproofing and 15% thermal insulation.
AREAS OF USE
It is used on all concrete surfaces,
Wood,
Metal,
Aerated concrete,
Gypsum board,
concrete board,
OSB plates,
Chipboard coatings.
APPLICATION
Surface Preparation:
Before application, surfaces should be cleaned from dirt, dust, old paint and free particles by mechanical means.
Deep pits and cracks should be filled by adding micro polymer primer material into the fiber mortar in the amount of water to be used in order to provide optical unity.
ISOWEIR FIXATOR should be applied to the cleaned surface with 200 - 250 gr per m².
ISOWEIR IZOÇATI application should be made after 1-2 hours depending on weather conditions.
Product Preparation and Application:
The product is ready to use, no thinning is required.
Mix well before use.
On surfaces such as wood, OSB, chipboard, etc., apply 2 coats directly with a steel trowel without using ISOWEIR FIXATOR, respecting the drying time between coats.
After applying 150 gr ISOWEIR FIXATOR per m2 on surfaces such as metal, glass, PVC, concrete, IZOÇATI is applied in 2 coats using 160 gr mesh on the 1st coat.
As a topcoat, a single coat of ISOWEIR IZOÇATI TOP COAT is applied with a roller in the color of the applied ISOWEIR IZOÇATI.
Wait a minimum of 2 hours between coats of ISOWEIR İZOÇATI depending on the air temperature.
Since the product is water-based, it dries with the removal of the water inside.
For this reason, the drying time shortens as the temperature increases.
Points to be Considered:
Eyes should be protected during the application.
It is recommended to wear gloves.
In case of skin contact, wash thoroughly with plenty of water and soap.
In case of contact with eyes, consult a doctor.
FEATURES, ADVANTAGES:
It is not affected by sun rays and has high U/V resistance.
The entire roof will be insulated with a monoblock insulation cover without joints.
Since chimney edges and drains are insulated with the same product, different materials are not used.
It is flexible and not affected by cold and heat.
It has high adhesion properties.
Easy to apply.
No doweling, nailing or heating is required for surface fixing.
Non-ignitable, self-extinguishing when exposed to a hot flame without spreading the flame.
Thanks to this feature, it meets the definition of “fire retardant coatings”.
