PRODUCTS

KR 2K

ISOWEIR KR 2K is a cement and acrylic based, two-component crystallized waterproofing mortar with capillary effect, which can be applied internally or externally, negatively and positively on concrete surfaces against leakage and surface water.

AREAS OF USE

  • Indoors and outdoors
  • Vertical and horizontal applications
  • Foundation and curtain waterproofing
  • Retaining walls
  • Terraces (provided that the top is protected)
  • Wet areas such as WC, bathroom, kitchen and balcony
  • Swimming pools
  • Water tanks
  • Tunnels
  • Elevator pits
  • Reinforced concrete pipes
  • Protecting concrete from water, carbonation and de-icing salts
  • Facilities such as spas and baths

APPLICATION

Surface Preparation:

  • Before application, surfaces should be cleaned from dirt, dust, old paint and free particles by mechanical means.
  • Application surfaces should be free of pits, fractures, segregation, mold defects, cracks, should be smooth and dust-free.
  • Application surfaces should be damp, dry surfaces should be moistened before application.
  • The surface should be fully saturated with water 24 hours before application and again 2 hours before moisturizing.
  • Ensure that no puddles of water form on the surfaces.

Product Preparation and Application:

  • ISOWEIR KR 2K “B” powder component is added to one drum (5 kg) of ISOWEIR KR 2K “A” powder component under continuous stirring.
  • After adding one bag (25 kg) of ISOWEIR KR 2K "A powder component", continue mixing for approximately 3 minutes.
  • Mixing must be done with a low speed (400 rpm) mixer and a mixing tip.
  • As a result of the mixing process, a homogeneous, lump-free and spreadable mortar is obtained.
  • The prepared mortar should be used within 30 - 60 minutes at the latest.
  • ISOWEIR KR 2K System is applied by brush or suitable spraying equipment.
  • Application is done in 2 or 3 coats.
  • Coats should be applied homogeneously and the application should be made in the same direction for each coat.
  • A drying time should be allowed between coats (at least 3 hours), but not more than 24 hours.

Points to be Considered:

  • Eyes should be protected during the application.
  • It is recommended to wear gloves.
  • In case of skin contact, wash thoroughly with plenty of water and soap.
  • In case of contact with eyes, consult a doctor.

FEATURES, ADVANTAGES:

  • It is resistant to negative and positive water pressures.
  • It has a capillary effect.
  • Its durability is high.
  • Easy to prepare and apply.
  • It can be applied with a brush or spraying machine.
  • The working time is long.
  • It has a very high adhesion performance and works together with the adhered surface.
  • It forms a solid layer impermeable to water.
  • The coats are cement based, so they adapt very well to damp concrete surfaces.
  • It does not shrink or crack.
  • It is resistant to chemicals and salt solutions in the soil.
  • It is permeable to water vapor.
  • It is resistant to freeze-thaw cycles.
  • It is used safely in drinking water tanks.