Laboratories, hospitals, industrial kitchens, wet processing areas in food, chemical and pharmaceutical industries,
Thermal and hydroelectric power plants,
Concrete and cement-based mineral surfaces,
In areas where non-slip and easy cleaning is required.
APPLICATION
Surface Preparation:
If the concrete is new, the floor concrete should be cured (~ 21 days) and the moisture content of the concrete should not exceed 4%.
Concrete surfaces should be thoroughly cleaned, dust and loose particles should be removed with rotating steel or vacuum cleaner, cracks and eyelet holes should be filled.
After surface preparation, the concrete floor should be primed with suitable ISOWEIR ZEEPAS primer material and made ready for topcoat application.
Do not apply on surfaces with insufficient waterproofing.
Do not apply on wet, high humidity and frozen surfaces.
Product Preparation and Application:
The mixing ratio should be 22 kg of Component A and 3 kg of Component B by weight.
Component A should be mixed with a low speed mixer until homogenized.
Then Component B should be added to component A and the mixture should be mixed at about 100 rpm for at least 2 minutes.
As the amount of contents you are mixing increases, you may need to increase your mixing time or mixing speed.
As soon as you start mixing, there will be a cloudy appearance in the system at first, and as the mixing continues, it will start to become transparent again.
Scrape the finished mixture into another clean container and mix again.
You can complete your process by pouring the mixture you mixed for the second time into the area where you will apply.
To minimize air entrainment (to avoid bubbles), mixing should not be done for too long and at high speed.
ISOWEIR ZEEPSON TIX 620S should be applied homogeneously with a trowel or roller to the prepared surface as an base coat, final preparation coat or top coating coat.
After making sure that the surface is completely covered, the application is completed by combing with the help of a satin and textured roller before the curing time expires in order to ensure a balanced distribution of the material and to give a pattern on the top coat.
After application, the floor should be protected from direct contact
with water for at least 48 hours.
Points to be Considered:
Eyes should be protected during the application.
It is recommended to wear gloves.
FEATURES, ADVANTAGES:
Thanks to its high thixotropic properties, it provides a textured and non-slip surface.
